HVAC & Plumbing Services in Grand Rapids, MI

Completed full system replacement of aging HVAC equipment with new high-efficiency furnace and air conditioning unit. Installed outdoor condenser on existing concrete pad with proper refrigerant line connections and electrical hookups. System was properly integrated with existing home ductwork and tested for optimal performance.

Installed new pressure regulator and mixing valve assembly on customer's boiler system. Connected copper supply lines to the brass valve components and verified proper pressure readings on the gauge. System now operating within normal parameters with no leaks observed at any connection points.

Responded to no heat complaint on a 3-year-old furnace system. Upon inspection of the internal components, examined motor assembly, electrical connections, and control board. Verified proper wiring configuration and functionality of all electrical components. System is now operating correctly and producing heat as designed.

Completed annual maintenance on 9-year-old Carrier furnace (model WT, manufactured 09-2026). Performed full tune-up including inspection of heat exchanger, burners, and electrical components. System is functioning properly with no issues identified; condensate drainage system and ductwork connections are in good condition.

Successfully completed installation of new residential furnace unit with PVC ventilation system. Connected all required ductwork, including proper venting configuration, and positioned unit on protective drip pan in basement mechanical room. System was fully tested and verified operational alongside existing water heater.

Successfully installed a 50-gallon natural gas water heater with 6-year warranty in customer's utility area. Unit was properly positioned on a metal drain pan, with all copper piping connections completed to code. Water heater is functioning correctly with no leaks detected during final inspection.

Performed annual heating maintenance on furnace system with ENE warranty 01-2034. Conducted comprehensive inspection of furnace components including internal wiring, ventilation system, and all PVC connections. System is functioning properly with no issues identified during the service visit.

Diagnosed 19-year-old furnace system with heavily dust-contaminated evaporator coils affecting system efficiency. Performed thorough cleaning of blower assembly and evaporator coils to restore proper airflow and heat exchange capacity.

Responded to service call for shower drain backup. Visual inspection revealed possible water damage around toilet base. Cleared blockage in shower drain using professional drain cleaning equipment, restoring proper drainage function.

Responded to client complaint of water line rattling throughout house when guest toilet is used. Inspected plumbing system and identified water hammer issue in supply lines. Installed water hammer arrestors on toilet supply line which successfully eliminated the noise and vibration when toilet is flushed.

Diagnosed 25+ year old furnace with limit switch failure as indicated by blinking HTX status light. Inspected aging system components including heat exchanger, ductwork connections, and drainage system in basement installation. Recommended replacement due to unit's advanced age, visible wear, and repair cost considerations versus efficiency benefits of modern equipment.

Responded to no-heat service call where furnace was not igniting. Upon inspection, identified a failed igniter as the root cause. Replaced the defective igniter component, tested system operation through multiple heating cycles, and confirmed proper ignition and heat production.

Responded to no-heat call for 25+ year old system with blinking status light indicating tripped limit switch. Diagnosed failed limit switch that was not resetting properly. Replaced limit switch, restoring normal heating operation and ensuring proper system safety functionality.

Responded to no heat call for a 14-year-old Carrier furnace. Upon inspection, found heat exchanger with significant rust and cracking, indicating failure. Advised customer of safety concerns and shut down unit to prevent carbon monoxide risks.

Relocated incorrectly installed cold water valve that was causing a leak in the basement plumbing system. Properly repositioned and secured the blue shut-off valve on the black pipe fittings above the copper supply lines, ensuring all connections were sealed and tested for proper function with the Bradford White water heater system.

Inspected 6-month-old EnergiAir WT 03-2035 unit reportedly damaged by falling ice. Found visible corrosion at mounting bracket and unit base, with significant snow and ice accumulation against the condenser. Confirmed heating function operational; cooling function could not be tested due to winter conditions.

Diagnosed and repaired water leak from humidifier connected to 12-year-old EcoAir furnace system. Identified failed water supply connection with visible bubbling in clear tube and water droplets on brass valve assembly. Replaced damaged components and verified proper operation of humidifier with no further leakage.

Performed complimentary furnace tune-up on 21-year-old Carrier system with failed heat exchanger. Documented water heater installation and electrical panel for replacement estimate. Customer notified of critical safety issue requiring system replacement.

Performed scheduled complimentary furnace tune-up on 6-year-old Carrier system. Completed full inspection of heat exchanger, gas valve, and electrical connections, confirming all components operating within specifications. System functioning properly with no issues identified; documentation completed with photographic verification.

Installed new condensate drainage system, connecting main pipe to existing plumbing infrastructure. Positioned and secured vertical discharge pipe with appropriate fittings in utility area. System was tested and verified to be functioning properly with no leaks observed.