Heating, AC, Plumbing & Generators in Kentwood, MI

Responded to service call for sump pump not draining properly following previous repair work. Upon arrival, conducted thorough inspection of the sump pump system and discharge line. Identified issue with exterior discharge point near property fence line where water was not flowing correctly. Cleared obstruction in discharge line and verified proper drainage away from foundation. Tested sump pump operation through multiple cycles to confirm water is now draining effectively through the exterior discharge point along fence perimeter. System restored to full working condition with proper water evacuation confirmed.

Completed full air conditioning system replacement at residential property. Removed existing outdoor condensing unit and installed new metallic gray AC condenser on existing concrete pad against exterior wall with beige vinyl siding. Unit positioned in side yard between landscaping shrubs for optimal airflow and access. Connected refrigerant lines, installed white PVC condensate drain line extending vertically from unit top, and verified all electrical connections. System tested and confirmed operational with no visible defects or irregularities.

Completed crankcase seal replacement on generator unit to address oil leakage. Disassembled necessary components to access crankshaft area, removed failed seal, cleaned mating surfaces, and installed new OEM crankcase seal with proper torque specifications. Recharged system oil to manufacturer specifications and verified no leaks at oil drain port. System tested and returned to normal operation.

Responded to heating system failure where furnace would not ignite unless thermostat was set 10 degrees above desired temperature. Upon inspection, found flame sensor rod heavily corroded with significant carbon buildup and heat damage preventing proper flame detection signal. Removed and replaced defective flame sensor with new component, tested ignition sequence for proper operation, and verified furnace now cycles normally at standard thermostat settings.

Completed annual cooling maintenance on 3-year-old Rheem air conditioning system. Performed comprehensive tune-up including inspection of outdoor unit, refrigerant lines, condensate drainage system, and all electrical connections. Verified proper insulation on refrigerant lines with foam wrap secured by zip ties, confirmed service port accessibility, and documented system condition with photos showing unit in good operating condition with no visible signs of wear, corrosion, or refrigerant leaks.

Responded to plumbing leak in basement area. Upon inspection, identified leaking copper pipe with brass fittings in exposed floor joist system above concrete block foundation wall. Documented existing conditions showing moisture staining on wooden joists and structural members, indicating active water intrusion. Assessed plumbing system configuration and determined source of leak requiring repair to prevent further water damage to structural components.

Completed annual cooling maintenance on 13-year-old Bryant air conditioning system. Performed comprehensive tune-up including inspection of outdoor condensing unit, refrigerant level verification, electrical connection testing, and condenser coil cleaning. All components operating within manufacturer specifications with no deficiencies noted at time of service.

Responded to water leak originating from furnace area. Upon arrival, identified active water accumulation on concrete floor with significant moisture staining and pooling near HVAC equipment. Inspected furnace and associated components to locate source of leak. Documented conditions with photographs showing extent of water damage on floor surface. Addressed immediate leak concern and provided customer with warranty information for equipment covered under existing protection plan expiring 01-2028.

Completed annual cooling maintenance tune-up on residential HVAC system. Inspected and photographed internal components including control board, condensate drainage system with PVC piping, electrical connections, and safety float switch. All systems operational and ready for cooling season.

Replaced refrigerator water supply line with new copper piping running through attic utility space to kitchen area. Secured line with proper mounting brackets and tested system for proper water flow and leak-free connections upon completion.

Completed annual cooling system maintenance and inspection on residential HVAC equipment. Performed comprehensive tune-up including filter evaluation, electrical connections check, refrigerant level assessment, condenser coil inspection, and system performance verification. All components operating within manufacturer specifications with no deficiencies noted at time of service.

Completed annual cooling maintenance on a 2011 EnergiAir system with 10 years of service history. Performed standard tune-up procedures and inspected condensate pump system in basement mechanical space, which was found operating properly with drain line connected and functioning as designed. Documented equipment condition with photos for service records.

Completed comprehensive ASTU-AC Super Tune-up on outdoor condensing unit with white casing and rounded square design. Upon arrival, customer was uncertain about current cooling performance and system age, though motor had been replaced within recent years. Performed full system inspection and diagnostics, including electrical testing, refrigerant level verification, and operational assessment of compressor and fan motor. Cleaned condenser coils which showed significant dust accumulation and outdoor weathering on horizontal fins. Verified proper function of all electrical connections and controls. Inspected refrigerant lines, insulation, and disconnect box mounted on exterior wall. Tested system startup and shutdown sequences, confirmed adequate airflow through black protective fan grille, and verified proper heat exchange operation. System restored to optimal operating condition. Additionally provided estimate for new AC pad installation as requested by customer.

Responded to emergency call for water leaking from refrigerator. Upon arrival, located the water supply line to the refrigerator and successfully shut off the water source to stop the active leak. Placed collection bucket with towel underneath affected area to capture residual water and prevent further damage to flooring. Inspected the refrigerator water line connection and identified the leak source at the supply hose fitting.

Completed full air conditioning system replacement at residential property. Installed new outdoor condensing unit with proper refrigerant line connections, electrical hookup, and mounting on concrete pad. System tested and verified operational, with all safety labels and manufacturer specifications properly displayed on equipment.

Completed comprehensive ASTU-AC Super Tune-up on 16-year-old air conditioning system. Performed full system inspection, cleaned condenser coils, checked refrigerant levels, tested electrical components, verified thermostat operation, and inspected condensate drain line. System operating within normal parameters with all components functioning properly.

Completed annual heating and cooling maintenance on 7-year-old EcoAir furnace and air conditioning system. Performed comprehensive tune-up including cleaning condensate drain line and drain pan, which showed mineral buildup and debris accumulation. Flushed drain system, verified proper drainage flow, and ensured all components were functioning correctly for optimal system performance.

Completed annual cooling system maintenance on 8-year-old EcoAir unit. Performed comprehensive tune-up including inspection of all major components, verified refrigerant levels, cleaned condenser coils, checked electrical connections, and tested system operation. Unit is functioning properly with no issues identified during the service visit.

# Laundry Room Plumbing Rework Completed comprehensive plumbing system rework in basement utility area. Reconfigured white PVC drainage piping with new vertical and horizontal runs, installed black coupling connectors, and secured all lines with proper metal clamps at appropriate intervals. Performed diagnostic testing of water heater/boiler unit and verified all connections for proper drainage flow and system integrity.

I apologize, but there appears to be a significant mismatch between the service type indicated (AC-Annual Cooling Visit) and the photo documentation provided, which shows only a toilet and bathroom flooring with no HVAC equipment visible. Without accurate visual documentation of the air conditioning system, components serviced, or equipment conditions, I cannot generate a proper technical description of AC maintenance work that was purportedly performed. To provide an accurate service summary, I would need photos showing the outdoor condensing unit, indoor evaporator coil, refrigerant pressures, electrical connections, or other relevant HVAC components that would have been inspected and serviced during an annual cooling maintenance visit.