Heating, Cooling, Plumbing, and Electrical Services in Ada

Converted residential heating system from liquid propane (LP) to natural gas (NG) fuel source. System included a Modine furnace less than one year old that was currently operational. Performed fuel conversion on the unit, verified proper gas pressure and combustion parameters, and tested system operation to ensure safe and efficient heating performance on natural gas supply.

Conducted on-site evaluation of existing standard tank water heater in basement utility area for replacement with tankless water heater system. Assessed current water heater installation including PVC venting configuration, gas supply line accessibility, and electrical requirements. Documented existing setup with photos showing current tank unit, surrounding utility space layout, and venting system utilizing PVC piping through ceiling joists. Additionally evaluated furnace conversion feasibility from propane to natural gas fuel source, examining current gas line infrastructure and equipment compatibility requirements for dual conversion project.

Completed full air conditioning system replacement at residential property. Removed existing aged cylindrical condenser unit and installed new Trane condensing unit in outdoor carport area against exterior wall. Replaced indoor air handler unit in basement mechanical room with new equipment. Installed new refrigerant line set with proper insulation, ran electrical conduit and wiring to both indoor and outdoor components, and connected PVC condensate drainage lines with appropriate fittings and supports. Verified all connections, tested system operation, and confirmed proper airflow through existing ductwork.

Completed annual cooling maintenance on 19-year-old Lennox system. Upon inspection, discovered excessive water accumulation in condensate drain pan with visible corrosion and mineral deposits on drain fittings and overflow safety switches. Disassembled and cleaned condensate drainage components, removing rust-colored staining and buildup from yellow plastic drain fittings. Cleared drainage system to restore proper water evacuation and prevent potential overflow issues. Documented system condition with photos for service records.

Completed annual cooling system maintenance on 15-year-old Goodman AC unit. Performed comprehensive tune-up including inspection of air handler, ductwork assembly, refrigerant lines, electrical connections, and condensate drainage system. All components inspected and found operating within normal parameters; system ready for cooling season.

Completed annual cooling maintenance on energiAir WT 08-2029 system. Inspected and cleaned condensate drain line, removing accumulated debris and sediment from drain components to ensure proper water evacuation. System operational and all components functioning within normal parameters.

Completed annual cooling maintenance visit on 2011 EnergiAir system under active warranty coverage through August 2031. Performed standard preventative maintenance procedures, system inspection, and documented equipment condition with photographic records. All components operating within normal parameters at time of service.

Completed QUOTR-quoted repair performing system conversion work. Conducted pressure testing and monitoring at two separate intervals (10:42 AM and 12:15 PM) to verify system integrity and proper operating pressures, with gauge readings confirming successful completion of the conversion process.

Completed annual cooling maintenance on a 10-year-old Bryant condensing unit manufactured in 2022. Performed comprehensive system inspection, verified unit levelness, checked condenser coil condition, and documented equipment status with photos. All components found operating within normal parameters with no immediate service needs identified.

Responded to water leak emergency in basement that triggered EPS system. Inspected sump pump system and surrounding area to identify source of water intrusion. Upon arrival, water had already dried up from previous day's flooding. Examined 7-year-old Carrier HVAC system, including air conditioning unit and furnace, as potential sources of water leak. Documented sump pump pit installation with standing water present, including float switch mechanism and PVC discharge pipe configuration. Photographed concrete floor conditions showing typical basement moisture indicators. Unable to definitively confirm leak source at time of inspection due to water having dissipated, but assessed AC condensate drain and furnace as most likely culprits based on customer report and system age.

Completed full air conditioning system replacement in basement mechanical room. Removed existing AC unit and installed new condensing unit with corresponding evaporator coil. Connected new equipment to existing furnace and ductwork system using properly sized refrigerant lines and black flexible duct transitions. Installed new condensate drain line with white PVC piping routed to existing drainage system. Made all necessary electrical connections and verified proper voltage and amperage at disconnect. Pressure tested refrigerant lines, evacuated system to proper micron level, and charged unit to manufacturer specifications. Commissioned system and verified proper airflow, temperature differential, and overall operation. All work performed to code and manufacturer guidelines.

Responded to service call for two-zone air conditioning system with one zone not functioning properly. Upon arrival, inspected 25-year-old system that had been previously upgraded with Honeywell Home HZ311 zone control panel. Evaluated zone damper operation and control wiring connections at equipment location. Examined zone damper actuator motor with red adjustment dial, verified proper mounting and mechanical operation. Tested zone control panel functionality, confirmed digital display and zone indicator lights operational. Checked damper motor positioning and response to thermostat calls. Verified Aprilaire humidifier controller settings and operation as part of overall system assessment. Inspected all visible wiring connections between zone control panel and damper actuators. System evaluation completed with photographic documentation of control equipment and damper actuator installation for service records.

Responded to no-cool complaint on 24-year-old Payne air conditioning system. Upon arrival, performed diagnostic testing at outdoor unit using multimeter to check electrical components, capacitor, and power supply at disconnect panel. Identified system failure and documented electrical connections and component conditions with photos for service records.

Completed annual cooling system maintenance and inspection on outdoor condensing unit. Performed comprehensive tune-up including cleaning condenser coils, checking refrigerant levels and pressures, testing electrical connections and capacitors, inspecting contactor operation, verifying proper airflow through condenser fan, and confirming overall system performance. Unit is operating within manufacturer specifications with warranty coverage extending through November 2029.

Responded to Plumbing Club Inspection for low hot water pressure issue on year-old water heater installed in May 2025. Performed diagnostic evaluation of water heater system, documented conditions with photographs, and provided assessment for multiple additional estimate requests from client.

Completed full HVAC system replacement including outdoor condensing unit and indoor air handler. Installed new beige cylindrical condensing unit on existing concrete pad with proper clearances beneath structural joists, positioned against building exterior with wood chip and gravel drainage surrounding foundation. Mounted new dark-colored air handler in interior utility closet with horizontal supply ductwork connection through wall. Verified all electrical connections, refrigerant lines, and ductwork transitions properly secured and sealed for optimal system performance.

Responded to no-heat call where furnace failed to operate during previous inspection. Upon arrival, accessed vacant property using provided entry code. Performed diagnostic evaluation of heating system and identified failed control board component preventing furnace operation. Circled and documented defective component on zoning control board, which showed ZONE2 and ZONE3 indicator LEDs illuminated but system unable to call for heat. Recommended control board replacement to restore heating function. Property owner notified of findings and repair options while out of town.

Responded to leaking garbage disposal in kitchen. Upon arrival, found 10-15 year old disposal unit that had been leaking for several days. Previous attempt at removal was unsuccessful. Removed old disposal unit from mounting assembly and disconnected drain lines and electrical connections. Installed new disposal unit, reconnected all plumbing and electrical components, tested for proper operation and verified no leaks present. System functioning properly upon completion.

Completed annual preventative maintenance inspection on 13-year-old EnergiAir cooling system with 2016 condenser model. Performed standard seasonal checkup including system evaluation, component inspection, and operational testing to ensure optimal performance for the cooling season.

Provided estimate for replacement of 50-gallon Bradford White automatic storage water heater experiencing slow leak. Documented existing unit specifications, venting configuration with metallic flue pipe, copper supply line connections with shut-off valves, and installation location in unfinished basement utility area.