HVAC & Plumbing Services in Grand Rapids, MI

Responded to service call for reported leaks under all sinks. Upon inspection, examined P-trap assemblies, supply lines, and connection points at multiple sink locations. Completed necessary repairs to eliminate leaks and verified proper drainage function with no remaining moisture issues.

Responded to no heat call and found thermostat was blank with no batteries installed. Installed new batteries, restored power to thermostat, and verified proper furnace operation. Unit is approximately 15 years old and is now functioning normally.

Diagnosed 24-year-old Amana furnace blowing cold air that requires power cycling to restore operation. Observed heavily soiled pleated filter causing restricted airflow, which likely contributes to system cycling issues. Recommended system replacement due to age and unreliable performance.

Responded to water leak service call for 18-year-old GDM furnace. Diagnosed leak originating from the exhaust vent connection and collector box. Performed inspection with diagnostic tools to verify issue and documented condition with photos of the HVAC system including PVC ventilation piping and internal furnace components.

Performed comprehensive FSTU on 7-year-old furnace in basement installation. Conducted full inspection of the system including ductwork connections, control panel functionality, and burner operation. All components were found to be in proper working order with no issues requiring immediate attention.

Responded to main line backup issue where previous service provider was unable to access cleanout. Located 3-inch PVC cleanout with corroded turquoise cap in wall cavity. Successfully removed and replaced damaged cap, then cleared blockage to restore proper drainage function.

Identified and repaired water leak originating from failed seal on water heater supply pipe connection. Inspected basement floor area affected by slow leak spread, confirmed no damage to surrounding tile flooring, and verified proper function of Defender water heater system after repair.

Successfully completed installation of a new furnace system and outdoor AC condenser unit. The furnace installation included an Aprilaire humidifier with proper ductwork connections in the basement utility area, while the outdoor unit was properly mounted on a concrete pad with electrical connections secured to the exterior wall.

Responded to service call for a clogged sink that had been draining slowly for 4-5 days. Upon inspection of the white PVC P-trap assembly under the vanity sink, discovered and cleared a blockage in the drain line. Verified proper drainage functionality after service completion with no issues in other fixtures.

Cleared recurring bathroom drainage issues in both sink and tub that had persisted for several months in a 90-year-old home, which previous chemical drain opener treatments had failed to resolve. Performed thorough drain cleaning service to remove accumulated debris and restore proper drainage functionality to both fixtures.

Successfully installed a new Carrier furnace unit in the utility room, complete with proper connection to existing ductwork system. All ventilation components were secured with appropriate metal fasteners, and system was verified to be in normal working condition with no leaks or abnormalities.

Accessed plumbing behind wall panel to diagnose slow draining tub. Inspected drain line configuration and cleared blockage causing drainage issue. System now operating properly with normal flow restored.

Successfully completed installation of new Amana furnace in basement utility room, properly connecting all necessary ductwork, PVC venting, and ensuring optimal placement alongside existing water heater. System was fully tested and verified operational with proper airflow through the newly installed components.

Performed annual heating maintenance on furnace and humidifier system per preventative maintenance agreement. Inspected electrical connections and wiring harness in control panel, noting proper wire routing and secure terminations. All components functioning within normal parameters; system left operating efficiently.

Performed diagnostic assessment on 11-year-old Concord central AC unit which is non-operational and requires replacement. Documented existing system configuration including forced air furnace with ductwork throughout residence. Photographed outdoor condensing unit showing significant wear and deteriorated components, as well as the indoor equipment connections and existing ductwork in utility space.

Responded to service call for damaged condenser unit. Upon inspection, identified impact damage to the outdoor unit from fallen ice. Documented damage with photos and notified customer that assessment is needed to determine if repair is possible or if full replacement will be required.

Completed annual heating maintenance on 12-year-old EnergiAir furnace. Performed comprehensive tune-up including inspection and cleaning of burner assemblies as shown in documentation photos. No humidifier present on system. System is functioning properly with expected service life until 2025.

Completed quoted repair work involving replacement of a damaged zone system. Removed deteriorated ductwork showing significant metal tears and deformation at connection points. Installed new galvanized sheet metal components to restore proper HVAC zoning function.

Completed annual heating maintenance on furnace and humidifier system (6-year service). Inspected internal electrical components including circuit board connections, blower motor assembly, and wiring integrity. All systems functioning properly with no issues identified.

Performed annual maintenance on EnergiAir furnace and humidifier system (model WT 08-2034). Inspected and photographed the humidifier unit, confirming proper installation of the evaporative water panel and verifying integrity of water supply connections including PVC and copper tubing. System is functioning within normal parameters.