Best AC, Heating, Plumbing & Generator Services Near You in Grandville, MI

Inspected the toilet tank and found the refill tube repeatedly detaching from the overflow tube, causing continuous running. Reseated and secured the refill tube to the overflow tube, then tested the fill valve and flush assembly to confirm proper shutoff and normal operation. Noted mineral buildup and staining inside the tank.

Performed annual heating tune-up on a 15-year-old Lennox furnace, including inspection of the air handler cabinet, ductwork connections, and condensate drain components. Accessed the blower assembly and found significant dust and debris buildup on the blower wheel blades, which can restrict airflow and reduce system efficiency. System was serviced as part of the recurring maintenance plan, and no humidifier service was performed on this visit.

Performed annual heating tune-up on the furnace, including inspection of the air handler cabinet, evaporator coil, and filter section. Found heavy dust and debris buildup on the cabinet interior and coil housing, along with deteriorating insulation near the coil, and noted staining and residue in the drain pan indicating prior moisture or condensate accumulation. No humidifier is installed on the system, and the unit is original to a 2013 install.

Removed the existing furnace and installed a new gas furnace in the basement mechanical area, connecting it to the existing sheet metal supply and return ductwork with sealed plenum transitions. Reconnected the Aprilaire humidifier, PVC condensate drain line, and gas supply, then verified proper operation and a clean, secure installation.

Performed annual heating maintenance on the furnace, including a full tune-up and inspection of the burner assembly, with burners removed and examined and found free of heavy rust, cracks, or other damage. Serviced the humidifier as part of the visit, and the system was returned to normal operation as part of the recurring maintenance plan.

Performed a full furnace super tune-up on an 11-year-old Payne unit, including inspection of the burner assembly, flame sensor, ignition system, blower components, and safety controls. A borescope inspection of the heat exchanger revealed a visible corrosion breach consistent with a pinhole perforation, and the customer was issued the heat exchanger failure notice detailing the associated carbon monoxide risk. The unit is recommended to remain out of service until the heat exchanger is repaired or the furnace is replaced.

Performed an on-site plumbing evaluation and estimate for a proposed laundry room and bathroom addition. Inspected the existing sink's drain and supply configuration, documenting the white plastic P-trap assembly with slip-joint couplings, braided supply lines, and chrome angle-stop valve. Noted corrosion and mineral buildup at the metal tailpiece-to-trap connection, along with staining on the cabinet floor and panels, and photographed all conditions to support scoping of new supply, drain, and venting tie-ins.

Installed a customer-supplied single-handle pull-out kitchen faucet at the double-basin sink and verified proper operation with a steady flow and no leaks at the connections. Replaced the existing PVC drain assembly beneath the sink, including the tailpiece, slip-joint nut, and elbow, and confirmed secure fittings and unobstructed drainage from both basins.

Responded to a recurring drain issue following a prior service visit and inspected the basement floor drain, which was found holding dark standing water with black tar-like debris and heavy grime buildup in the surrounding area. Assessed the drain and adjoining piping, including the capped 2" line and the patched concrete at the pipe base, to evaluate the source of the recurring blockage and drainage restriction.

Completed a plumbing inspection of the residence, including the basement utility area and laundry room. Observed white PVC supply and drain piping secured with clamps, a shutoff valve, and an existing reverse osmosis system with storage tank and filter housing mounted on plywood backing; no visible leaks, corrosion, or damage were noted. Laundry appliances and surrounding surfaces showed no abnormal conditions, and the home was assessed for the requested reverse osmosis, water pump, and filtration system upgrades.

Responded to a no-heat call on a 16-year-old furnace reported as inoperative for several days following an electrical issue, with the circuit breaker verified as not at fault. Photos document a temporary power service setup at the exterior of the residence, with the meter socket, conduits, and supply cables staged and marked with caution signage and tape. Electrical supply issue was identified as the root cause of the heating system outage, and work was completed to restore power service to the furnace.

Responded to a no-heat call on a 7-year-old gas furnace where the home was holding 63-64°F against a 68°F setpoint. Inspected the furnace cabinet and verified burner ignition and flame presentation, finding a stable blue flame, and checked the gas valve, wiring connections, and inducer motor operation. Noted crusty residue at the gas line joint near the valve and discoloration in the cabinet, and confirmed the PVC vent connection and coupling clamp were secure. System was operating and producing heat at the time of departure.

Performed an on-site assessment and estimate for replacement of an existing Whirlpool atmospheric-vent water heater. Inspected the tank, draft hood, and galvanized flue, noting dented vent piping with discoloration, flexible water connectors, and heavy rust and corrosion on the adjacent cast iron pipe and threaded coupling. Documented the installation conditions with photos to support recommendations for the new unit installation, including venting and piping upgrades.

Installed a new Bradford White gas water heater in the basement utility area, set upright within a drain pan on the concrete floor. Connected the gas supply with a control valve, the water supply lines with a brass ball valve, and the flue to the existing vent, with insulation on the copper supply piping. Verified a secure, leak-free installation with no visible damage.

Performed annual heating inspection on a 16-year-old furnace, including borescope examination of the heat exchanger. Imaging revealed a perforation with an associated hairline crack and rust streaking along the seam, indicating heat exchanger failure. Documented findings with photos and recommended heat exchanger or furnace replacement, as continued operation poses a carbon monoxide safety risk.

Installed new vertical drain stack through concrete foundation with proper underground drainage connection. Installed backwater valve assembly with PVC piping configuration in basement mechanical room, including multiple fittings and directional connections to prevent sewage backup. All components secured to foundation wall with appropriate support and access for future maintenance.

Completed annual heating maintenance and tune-up on furnace and humidifier system. Performed comprehensive inspection of all heating components, verified proper operation of burners, heat exchanger, blower motor, and safety controls. Inspected and serviced humidifier unit, checked water supply and drainage lines. Replaced air filter and tested system performance. Photographed equipment condition and service label documentation showing system passed inspection. Provided quotes for installation of polarized media air filter and UV media light. Assessed exterior AC unit for leveling requirements and identified missing vent section requiring repair.

Responded to emergency service call for leaking water heater with water supply shut off. Upon arrival, inspected 17-year-old residential water heater located in basement utility area showing active water leakage at base. Unit exhibited age-related deterioration and compromised tank integrity consistent with end of serviceable life expectancy. Documented existing installation configuration including gas connections, venting system, and plumbing connections. Photographed water heater positioning between wooden framing and concrete block walls, noting accessible clearances and utility room layout. Provided estimate for complete water heater replacement including removal of existing failed unit and installation of new equipment to restore hot water service to residence.

Responded to emergency call for garbage disposal drainage issue where discharge pipe separated from end cap, causing flooding beneath kitchen sink. Inspected under-sink plumbing assembly, reconnected and secured white PVC drain pipe to disposal unit, verified all coupling joints were properly seated and tightened, and tested system for leaks to confirm proper drainage function restored.

Completed comprehensive estimate for full HVAC system replacement including new furnace, air conditioning unit, and complete ductwork installation. Existing equipment consists of a 17-year-old Utica boiler and 25-year-old Heil AC unit, both scheduled for removal and replacement. Assessed finished basement area with drop ceiling and upper-level spaces to determine equipment specifications and ductwork routing requirements for complete system conversion.