HVAC, Plumbing & Generator Services in Plainwell, MI

Completed annual cooling maintenance on 2021 EnergiAir system. Inspected and photographed air filter showing clean condition with proper airflow. Verified refrigerant lines, condensate drainage system, and safety float switch operation with all components functioning within normal parameters.

Completed annual cooling maintenance on 7-year-old Trane system. Performed comprehensive tune-up including inspection of all mechanical and electrical components, refrigerant lines, condensate drainage system, and ductwork connections. Documented equipment condition with photos showing air filter status and HVAC components in mechanical space.

Completed comprehensive AC Super Tune-up on residential system, performing detailed inspection of all mechanical and electrical components within the air handler compartment. Observed evidence of moisture exposure with rust discoloration on the condensate drain pan, noted system age showing general wear on internal components, and verified all electrical connections, refrigerant lines, and motor assembly were functioning properly with no immediate service needs identified.

Completed annual cooling system maintenance and inspection. Documented existing air filter condition showing pleated media filter with securing straps in place at basement air handler location. Performed comprehensive tune-up procedures per manufacturer specifications to ensure optimal system performance for the cooling season.

Completed annual preventative maintenance inspection on Generac Guardian 18kW standby generator unit. Performed comprehensive system evaluation including visual inspection of exterior housing, control panel functionality verification, and documentation of unit condition. Generator found in operational status with normal wear consistent with age, maintaining proper positioning on concrete pad with appropriate clearances from surrounding structures and landscaping.

Responded to water leak concern at furnace when AC unit was activated. Upon inspection, found water accumulation in condensate drain pan of air handling unit. Examined 3-year-old furnace and 10-month-old Carrier AC system. Inspected drain pan for proper drainage, checked condensate line routing, and verified trap configuration. Documented moisture staining and mineral deposits in collection pan indicating drainage issue. Photographed affected components showing water damage patterns on interior surfaces and discoloration in drain pan assembly. Assessed condensate management system for blockages or improper pitch that would cause water backup into furnace cabinet when cooling system operates.

Responded to water leak service call where system had shut down due to water in the evaporator pan. Upon inspection, discovered evaporator coil with heavy frost and ice accumulation, indicating a freeze-up condition that caused excessive condensation and pan overflow. Replaced faulty evaporator pan float switch that had triggered system shutdown as designed to prevent water damage. Addressed underlying freeze-up issue by checking airflow restrictions and system operation. Verified proper drainage through condensate line and PVC piping system. System restored to normal operation with proper safety controls functioning.

Responded to main upstairs bathroom toilet that was continuously running when not in use, requiring customer to shut off main water valve to stop flow into tank. Diagnosed and repaired faulty fill valve assembly that was preventing proper shut-off, restoring normal operation and eliminating constant water flow issue that had been present since January.

Completed annual cooling maintenance on 2017 Goodman 24 SEER unit. Performed comprehensive system inspection including refrigerant levels, electrical connections, condensate drain functionality, and airflow verification. All components operating within manufacturer specifications; system cleaned, tested, and left in proper working condition.

Completed annual cooling maintenance on 12-year-old Rheem air conditioning system. Performed comprehensive tune-up including system inspection, cleaned condensate drain pan and verified proper drainage, checked refrigerant levels, tested electrical connections, and confirmed unit operational efficiency. All components functioning within manufacturer specifications.

Responded to no-cooling call on 2-year-old EnergiAir unit where condenser would not run and made no sound. Customer reported unit briefly operated after power cycling but failed again within minutes. Upon inspection, diagnosed failed capacitor preventing compressor and condenser fan operation. Replaced defective capacitor with properly rated component, verified all electrical connections secure, and tested system through complete cooling cycle. Unit now operating within normal parameters with proper amperage draw and temperature differential.

Completed annual cooling maintenance on EnergiAir system in residential basement installation. Inspected air handler unit, verified proper operation of condensate drainage system with white PVC piping, and confirmed all components functioning correctly in active construction environment.

Responded to service call for Mitsubishi mini split system experiencing loud constant noise during operation and intermittent startup issues. Inspected indoor unit and accessed control board assembly to diagnose noise source and electrical concerns. Documented internal wiring connections and circuit board configuration showing multiple connector points (CN24, CN112, CN1R1, CN1S1) for troubleshooting purposes. System remained operational and cooling throughout inspection.

Completed installation of a 40-gallon natural gas water heater in basement utility room. Connected all copper supply lines with brass fittings to existing plumbing system, integrated white PEX piping, and verified proper connections to building's hot water distribution network. Unit is fully operational with 6-year parts and labor warranty coverage.

Responded to no-ignition complaint on 15-year-old residential water heater. Customer had previously replaced thermocouple without resolving issue. Confirmed gas supply present and spark generation occurring at pilot assembly. Performed diagnostic testing and determined gas control valve failure preventing proper gas flow to pilot and main burner despite adequate spark and thermocouple function. Recommended water heater replacement due to age of unit and cost-effectiveness compared to repair of failed gas valve on older equipment.

Completed annual cooling maintenance on 10-year-old Goodman air conditioning system. Performed comprehensive tune-up including inspection of outdoor condenser unit, verified proper operation of compressor and fan motor, checked refrigerant levels and pressures, cleaned condenser coils, and inspected electrical connections at disconnect box. Unit operating within manufacturer specifications upon completion of service.

Completed annual cooling maintenance on 16-year-old Allied air conditioning system. Upon arrival, found outdoor condenser unit heavily soiled with significant accumulation of dirt, dust, and dried plant debris including vines draped across coil surfaces. Cleared all organic matter and debris from condenser coil and surrounding unit. Performed thorough coil cleaning to restore proper airflow and heat transfer efficiency. Inspected unit components, verified system operation, and confirmed equipment functioning properly following maintenance procedures.

Conducted on-site assessment for whole-house backup generator installation to address recurring power outages during storm events. Evaluated existing natural gas line accessibility and capacity for generator connection. Inspected attic space and structural framing to determine optimal routing for electrical conduit and gas line extensions. Documented current electrical panel configuration and available space for automatic transfer switch installation. Photographed attic framing, floor joists, and potential penetration points for conduit runs. Assessed exterior locations for generator placement considering clearance requirements, gas line proximity, and code compliance. Verified existing 2023 HVAC system compatibility with backup power requirements. Provided detailed estimate for complete standby generator system including unit specifications, automatic transfer switch, gas line connection, electrical integration, and installation labor.

Responded to no cooling call affecting entire home on EnergiAir system installed August 2023. Upon arrival, performed diagnostic evaluation of outdoor condensing unit. Identified failed contactor with visible corrosion on mounting hardware and electrical connections. Contactor showed signs of age-related deterioration with accumulated debris around electrical components. Removed defective contactor assembly and disconnected multiple circuit wires including line voltage and control wiring. Installed replacement contactor, reconnected all electrical terminations to proper terminals, and verified secure wire connections. Tested system operation and confirmed proper startup sequence with contactor engaging correctly. System restored to full cooling operation with all safety controls functioning as designed.

Responded to customer report of refrigerator causing electrical shock when touched. Upon inspection, discovered the dedicated refrigerator outlet lacked proper grounding conductor and exhibited a discolored neutral wire (brown instead of white), indicating potential overheating or age-related deterioration. Inspected main electrical panel to assess overall system condition and grounding infrastructure. Documented panel configuration showing multiple circuit breakers across two vertical bus bars with various branch circuits. Observed mixed wire gauging and color coding throughout panel, consistent with additions made over time. Photographed panel interior showing wire routing, breaker arrangement, and main disconnect components for reference. Identified potential safety concerns requiring immediate attention: absence of equipment grounding conductor at refrigerator outlet poses shock hazard, and discolored neutral wire suggests compromised conductor integrity that could lead to overheat