HVAC & Plumbing Services in Wyoming, MI

Successfully installed new toilet, connecting supply line to existing shut-off valve and securing unit to floor. Observed bathtub drainage issues and problematic stopper mechanism, which will require separate service appointment for resolution.

Successfully installed a new residential water heater in basement utility area. Completed all necessary copper pipe connections and verified proper operation of the unit. Final inspection confirmed compliant installation with all safety requirements met.

Responded to service call for a Carrier furnace displaying error code 31. Upon inspection of the 12-year-old unit in a confined space, found the furnace was still operational despite the error code. Documented the condition with photos of the interior components and surrounding mechanical space for future reference.

Successfully installed new furnace system in basement utility room. Unit was properly secured against concrete block wall with all required connections (gas, electrical, condensate) completed to code. Ensured proper condensate drainage with installation of pump and drain pan beneath system.

Completed annual heating maintenance on 4-year-old EnergiAir furnace (WT 02-2031, manufactured 2020). Inspected PVC venting system, electrical connections, and condensate pump for proper operation. Visual inspection showed all components functioning normally with no immediate concerns. No humidifier present in the system.

Completed annual cooling maintenance on 17-year-old International Comfort Products air conditioner for Comfort Club member. Inspected condensate drain system, electrical connections, and refrigerant lines. Unit is functioning properly despite its age, with condensate drain pan in place to prevent water damage.

Completed annual heating maintenance on EnergiAir WT 12-2033 furnace (manufactured 2011). Inspected condensate drain system and verified proper installation of PVC piping and drain connections. Photographic documentation taken of the furnace components and drain assembly showing system in functional condition with no visible leaks or damage.

Performed annual tune-up on 10-year-old EnergiAir furnace in basement utility area. Observed some moisture concerns near the unit as evidenced by damp concrete floor with discoloration. Completed standard maintenance procedures and documented system condition with photos.

Performed complimentary annual furnace tune-up on a 1-year-old EnergiAir WT 02-2035 heating system. Inspected all components, cleaned and tested the unit, and verified proper operation with no issues identified. System is functioning within manufacturer specifications with no humidity control concerns noted.

Inspected 18-year-old Bradford White water heater due to customer complaint of rapidly depleting hot water. Discovered significant sediment buildup in tank affecting heating efficiency. Performed system flush to remove accumulated sediment and restored proper hot water capacity.

Successfully installed Everest furnace system with proper ventilation connections including PVC intake/exhaust pipes connected to existing ductwork. Mounted supplementary wall humidifier unit and completed all electrical connections to ensure proper system operation.

Completed kitchen plumbing rough-in work for renovation project, installing copper and PVC supply lines through floor. Positioned and secured piping according to project specifications, ensuring proper placement for future fixture installation in the concrete block wall construction area.

Responded to no-heat call and inspected wiring connections inside HVAC system. Identified and repaired compromised electrical connections at junction point where multiple colored wires (green, red, purple, yellow) were improperly terminated. System restored to proper operation after wiring repair.

Performed annual heating maintenance on 2012 CM system. Conducted comprehensive inspection and tune-up of furnace components. System is operating normally with warranty valid until 3-2026; no humidifier present.

Performed annual heating tune-up on 9-year-old ENE system with humidifier. Verified level installation of HVAC components and inspected sump pump system with proper discharge piping. Checked ductwork connections and heat exchanger components; all systems functioning properly.

Successfully completed installation of new furnace in basement utility area. Unit was properly mounted on platform with all required PVC ventilation/drainage connections established and connected to existing ductwork. System was tested and verified operational with all appropriate warning labels affixed to equipment.

Replaced internal toilet components in client's Kohler K3977 Wellworth toilet with new manufacturer parts. Removed old flush valve mechanism and fill valve, installing new Kohler guts per client's pre-ordered specifications. Tested flushing operation and confirmed proper water level and function after installation.

Completed annual heating maintenance on 4-year-old EnergiAir furnace. Inspected and verified proper operation of condensate pump system, including all PVC drain connections and discharge hose. Noted minor water staining on concrete floor near unit but confirmed pump is functioning correctly with no active leaks.

Completed Annual Heating Visit including furnace and humidifier tune-up. Inspected copper plumbing connections and verified proper mounting of HVAC components. System has warranty coverage through 12/2034 with current components showing normal wear but functioning properly.

Performed annual tune-up on 9-year-old Goodman furnace. Inspected interior components including drain pan which showed signs of algae growth. Documented condition with photos of mechanical components and drainage system for service records.