HVAC & Plumbing Services in Wyoming, MI

Completed QUOTR repair by raising laundry box to proper height for customer's washing machine connections. Installed new hammer arrestors on both hot and cold water supply lines and ensured proper connection of flexible supply lines and drainage hose. Total service time: 2.5 hours.

Installed 4x35 liner through concrete block wall foundation. Verified proper connection and sealing at penetration point. Documented installation with photos showing completed duct penetration and support bracket placement.

Responded to service call for leaking garage spigot. Inspected the area and found water accumulation in catch bucket below brass shutoff valves. Repaired leaking connection at water supply lines and verified proper operation with no further leakage.

Conducted assessment of 16-year-old water heater that failed to operate. Diagnosed multiple issues including pilot light failure and evidence of leakage into catch basin. After thorough inspection of gas valve assembly, tankless components, and ventilation system through brick wall, determined unit requires replacement due to age and deteriorating condition.

Successfully installed new furnace in basement utility room, replacing older unit. Installation included all necessary connections to existing PVC venting system. Completed all required paperwork for financing and documented installation with photos.

Performed annual heating maintenance on 13-year-old Carrier furnace. Inspected condensate drain system and verified proper operation of safety switches and pressure monitoring equipment. System is functioning correctly with all components in serviceable condition.

Successfully installed new Lennox Elite Series HVAC system including outdoor condensing unit on concrete pad with proper connections to the home. Complete installation included indoor furnace unit with PVC venting and ADEX-CLASSIC component, all properly connected to electrical panel and ductwork in utility area.

Successfully completed installation of a standard residential water heater in utility area, including proper connection of copper supply/return lines and PVC piping. Mounted blue expansion tank on wall above unit and ensured all necessary valves, fittings, and electrical connections were properly installed according to manufacturer specifications. System was tested and confirmed operational with appropriate water flow and temperature.

Completed annual heating maintenance on a 4-year-old Carrier furnace (model WT 02-2031). Performed comprehensive inspection with front panel removed to examine blower motor, electrical components, and exhaust flue. System is functioning properly with no operational issues identified. Photographic documentation of equipment and internal components was taken for service records.

Successfully completed installation of new Aprilaire furnace system with proper ductwork connections and exhaust venting. System was integrated with existing HydroJet water heater and all necessary PVC piping was installed according to manufacturer specifications.

Performed annual heating service on 15-year-old furnace system. Inspected ductwork, electrical connections, and safety systems - all components found in good working condition with proper installation. System received approval stickers and is operating within manufacturer specifications.

Performed annual maintenance on 11-year-old Carrier furnace. Inspected condensate drain system and noted mineral buildup in drain pan. Cleaned components and verified proper drainage function to ensure efficient operation for the heating season.

Diagnosed 9-year-old water heater with active leak at tank base and no hot water output. Customer had correctly shut off water supply and power to unit prior to arrival. Confirmed tank failure requiring full replacement due to age and deterioration visible at bottom of tank.

Responded to no heat call for 23-year-old furnace with Energi Air system. Diagnosed failed circuit board showing visible damage on PCB. Replaced control board and verified proper operation of heating system before departure.

Responded to a plumbing leak call regarding a Neptune valve installation. Inspected the valve assembly mounted against wooden wall paneling with insulation material and identified the source of leakage affecting the kitchen sink area. Replaced faulty valve components and performed pressure testing to confirm proper function and verify leak resolution.

Responded to service call for furnace with ignition lockout. Diagnosed failed heat exchanger during inspection of residential HVAC system. Provided customer with estimate for replacement furnace unit after documenting current installation configuration and surrounding utility area connections.

Performed annual heating system maintenance on a 3-year-old EnergiAir unit with warranty valid through 01-2028. Inspected condensate pump system, noting proper drainage function with some mineral buildup present. Completed standard furnace and humidifier tune-up procedures as per recurring service agreement.

Performed annual heating maintenance on 20-year-old furnace. Inspected control board (1170-83-3001 REV.B) with AUTO STAGE switch and terminal connections (Y/Y2, Y1, G, W2). All wire connections and components appear in good condition with no visible damage or deterioration.

Responded to service call for two leaking toilets requiring flush valve replacements. Addressed suspected leak between toilet tank and bowl mount. Also examined bathroom sink pop-up drain issue and relocated washer shut-off valves to improve accessibility.

Performed annual heating maintenance on furnace with humidifier. Inspected and replaced dirty filter showing significant dust accumulation. System components including copper connections and valves were examined and found in good working condition. All services completed per 4-year energy plan requirements.