HVAC & Plumbing Services in Grand Rapids, MI

Responded to water leak service call for 1-year-old Carrier furnace. Discovered condensate drain line was clogged, causing water to pool on concrete floor beneath unit. Cleared blockage, cleaned drain assembly, and verified proper drainage function. System is now operating correctly with no signs of leakage.

Conducted site assessment for replacement condenser at single-family residence with existing 3-year-old AC system. Inspected basement utility area containing furnace unit with connected PVC drain pipes and flexible ductwork, adjacent water heater, and examined ceiling structure with exposed joists and insulated ducting. Documented current installation configuration and measurements to prepare accurate quote for new condenser installation.

Diagnosed 30-year-old garage heater that failed shortly after recent electric board replacement. Inspection of the MAXX ceiling-mounted unit revealed electrical connection issues at the control panel that were preventing proper heating function. Repaired faulty wiring connections and verified system operation with successful heat cycle test.

Inspected electrical panel and water heater in response to sump pump issue. Verified power supply to sump pump circuit and checked connections. Resolved toilet flushing problems by adjusting water flow and activating bathhouse water service as requested.

Responded to a slow leak on the house side of the water meter that had been ongoing for approximately two years in a 78-year-old home. Inspection revealed water staining on floor tiles near the meter installation area with aging metal pipes showing signs of minor corrosion at connection points. Repaired the compromised section of plumbing with appropriate fittings to resolve the persistent leak issue.

Performed annual heating maintenance on 8-year-old furnace. Inspected internal components including circuit board and wiring connections. Noted significant copper pipe corrosion with blue-green oxidation in the crawl space/basement area, suggesting possible water leakage or high humidity conditions that require attention.

Successfully completed installation of Amana air conditioning system, including outdoor condensing unit mounted on concrete pad and new furnace with properly connected ductwork in utility area. System was fully tested and payment was collected upon completion.

Successfully installed a 3" clean out and performed drain cleaning on 3" plumbing system in a confined wall space with exposed framing. Accessed and serviced pipes within the utility area that showed previous moisture issues, completing the quoted repair work as specified.

Completed heat exchanger replacement as per quoted repair. Removed old copper coils showing oxidation and surface tarnishing, and installed new heat exchanger assembly. System functioning properly after 4-hour installation with all connections verified and tested.

Returned to property to complete rewiring of two basement air handlers as previously quoted. Inspected and reconnected control wiring at both units, ensuring proper connections with wire nuts and verifying all terminations. Tested system operation after rewiring to confirm proper functionality of both air handlers.

Responded to service call for multiple plumbing issues affecting one toilet and two sinks. Inspected and repaired corroded supply line connection at toilet with significant mineral buildup. Serviced kitchen and bathroom sink P-traps showing signs of age and deterioration, cleaning accumulated residue at drain connections to restore proper drainage function.

Successfully completed installation of new furnace and air conditioning system as scheduled. Installed furnace unit on platform with proper PVC venting and connected to existing ductwork in utility area. Mounted AC condensing unit on concrete pad with appropriate refrigerant line connections and drainage setup.

Completed annual heating tune-up on 11-year-old Everest furnace system with integrated humidifier. Inspected all components, verified proper operation of intake/exhaust PVC piping, and confirmed system is functioning within manufacturer specifications. Equipment is located in basement mechanical area adjacent to water heater.

Performed inspection of a 2009 40-gallon gas water heater with recurring pilot light failure issues. Examined the existing ventilation system, which includes galvanized steel ductwork, flexible stainless steel water lines, and brass fittings. Provided customer with replacement options for complete tank installation and removal of the aging unit.

Performed annual heating service on a 3-year-old Lennox system. Observed corrosion at the condensate drain connection with visible rust deposits around the rubber gasket. Completed standard furnace tune-up; system is now operating within normal parameters.

Conducted inspection and installation of new garbage disposal system in 1960s single-family residence. Existing plumbing under sink features standard PVC drain assembly with P-trap configuration and copper supply lines, all in good working condition. Documented current plumbing setup with photos to ensure proper installation compatibility with the home's 60-year-old plumbing infrastructure.

Completed diagnostic assessment of 16-year-old water heater with temperature regulation issues. Unit is still functional but showing age-related performance decline. Provided customer with replacement options and quote as requested, documenting current installation configuration with photos for proper sizing of potential replacement unit.

Successfully completed furnace installation in basement utility area. Installed new residential HVAC unit with proper PVC venting, condensate drainage system, and connection to existing ductwork. System was tested and verified to be functioning correctly.

Performed complimentary annual boiler tune-up on 16-year-old system with CM from 2020. Inspection revealed significant copper pipe corrosion with rust and teal-colored oxidation at solder joints. Used DEPSTECH camera to examine interior piping, documenting extensive internal corrosion and sediment buildup that requires attention.

Installed nail plates to protect plumbing lines and properly supported piping in wall bays. Upgraded to larger laundry box and hard-piped gas line connection to laundry box per code requirements. All work completed in coordination with other trades to ensure proper installation within framed wall cavity.