Reputable HVAC, Plumbing & Generator Services in Zeeland, MI

Completed annual cooling system maintenance on a 19-year-old International Comfort Products unit with a 2018 condenser model. Performed comprehensive tune-up including system inspection, cleaning, and operational testing to ensure optimal performance for the cooling season.

Conducted comprehensive assessment of existing 20-year-old central heating and air conditioning system for replacement estimate. Evaluated current furnace and AC unit configuration, documented existing ductwork connections, plenum assembly, and venting system. Photographed water heater installation with associated plumbing connections, insulated supply lines, and gas shut-off valve for reference during future HVAC system replacement planning.

Responded to service call for 9-year-old Bosch geothermal unit continuously running water regardless of heating or cooling demand. Upon inspection, identified failed flow center assembly with malfunctioning zone valve causing constant water circulation through the system. Photographed existing plumbing configuration showing corroded copper piping, backflow preventer, expansion tank, and isolation valves within the mechanical room. Recommended replacement of defective flow control components to restore proper system operation and prevent unnecessary water flow and energy consumption.

Conducted on-site estimate for furnace and air conditioning system replacement. Assessed existing HVAC equipment in mechanical room, including current furnace unit with PVC venting system and associated ductwork configuration. Documented existing system layout, ductwork conditions, and installation requirements for replacement equipment sizing and specifications.

Completed annual cooling maintenance on 1-year-old Bryant air conditioning system. Performed comprehensive tune-up including inspection of outdoor condenser unit, electrical components, capacitor, contactors, and wiring connections. All system components found operating within normal parameters, pressures checked and verified proper refrigerant charge. Unit serviced and ready for cooling season.

Completed annual cooling system maintenance on EnergiAir unit under active warranty coverage. Performed comprehensive inspection of evaporator coil assembly, noting minor dust accumulation on fin surfaces but overall satisfactory heat exchange component condition. Inspected return air grille and documented moderate dust and debris buildup between louvers and in recessed areas, typical of normal system operation. All photographic documentation captured for warranty and maintenance records.

Completed annual cooling system tune-up and furnace maintenance on residential HVAC system. Performed comprehensive inspection of indoor furnace unit with integrated Honeywell Home humidifier and outdoor condensing unit. Inspected all electrical connections, ductwork, condensate drain lines, and system controls. Noted exterior coil surfaces on outdoor unit showing accumulation of dirt, pollen, and debris on protective mesh screening with visible moisture streaking. Verified proper operation of all system components and confirmed unit functionality for continued seasonal use.

Completed comprehensive AC Super Tune-up including full system inspection of electrical components, control board, and wiring connections. Inspected condensate drain pan and verified proper drainage function with no blockages detected. All safety labels confirmed in place and system operating within normal parameters.

Responded to no-cooling call on residential air conditioning system. Upon inspection, found outdoor unit with heavily soiled electrical disconnect box and capacitor assembly covered in dirt, debris, and organic matter. Wiring connections showed significant weathering and contamination. Cleaned electrical components, inspected capacitor and contactor for proper operation, and verified compressor functionality. Unit restored to normal cooling operation.

Responded to service call for gas line evaluation and quote preparation. Inspected existing gas piping system in basement area, identifying sections of galvanized pipe requiring assessment for potential replacement. Documented current installation configuration including pipe routing along ceiling joists and connections to mechanical equipment. Photographed existing gas line components, pipe materials, and accessibility conditions to support accurate quote development for gas line modification or replacement work.

# AC No Cooling - 16 Year Old Amana System Responded to service call for air conditioning system not cooling properly. Upon arrival, inspected 16-year-old Amana outdoor condensing unit located on exterior of residence. **Inspection Findings:** - Outdoor unit accessible with electrical disconnect and refrigerant lines properly installed - Significant deterioration observed inside electrical compartment - Extensive rust staining, dirt accumulation, and debris buildup throughout interior housing - Capacitor and wiring connections inspected - multiple colored wire terminals present on cylindrical capacitor - Evidence of moisture intrusion and environmental exposure causing interior component degradation **Work Performed:** - Performed visual inspection of outdoor condensing unit - Opened electrical compartment to assess internal components - Documented condition of capacitor, wiring, and interior housing - Photographed equipment condition for service records - Assessed overall system de

Responded to emergency call for burst pipe in basement caused by winter freeze conditions. Upon arrival, assessed damage and located the failed section of copper supply line. Cut out damaged pipe segment and prepared clean ends for repair. Installed new copper pipe section with brass compression fittings to restore water supply integrity. Cut access panel in interior wall to reach affected plumbing. Tested system for leaks and proper water pressure. Shut off exterior hose bib to prevent future freeze damage. All repairs completed successfully with no active leaks detected.

Completed annual cooling system tune-up and preventative maintenance on 9-year-old air conditioning unit. Performed standard inspection protocols, utilized refrigerant recovery equipment for system diagnostics, and verified proper operation of all components. System found to be functioning within normal parameters with no immediate service concerns identified.

Completed combined furnace and water heater estimate for property in flood zone. Inspected 29-year-old Bradford White water heater and existing HVAC furnace system, verified sump pump operation to ensure proper functionality in case of water heater failure. Provided quotes for both equipment replacement and repair options, including recommendation for installation of drain pan under water heater for flood protection.

Completed installation of a 40-gallon tall natural gas water heater manufactured by Bradford White Corporation in basement utility area. Unit was properly positioned, connected to existing copper supply lines with brass fittings and valves, and vented through metallic exhaust vent pipe in accordance with manufacturer specifications and local code requirements.

Responded to service call for leaking water heater over 20 years old. Upon arrival, inspected residential water heater located in basement utility area adjacent to furnace system. Identified active leak at plumbing connections and assessed overall condition of unit. Documented equipment age and deterioration through photographic documentation showing water heater installation, surrounding HVAC equipment, and mechanical room configuration. Due to advanced age of unit exceeding typical service life expectancy, recommended replacement rather than repair. Customer opted for cash/check without warranty coverage.

Completed full HVAC system replacement including outdoor condensing unit and indoor air handler/furnace assembly. Installed new condenser on existing concrete pad against exterior wall with proper clearances maintained. Mounted unit features horizontal louver grille design with manufacturer specifications clearly labeled. Interior installation includes new furnace unit with dual vertical metallic supply and return ductwork, properly insulated with reflective foil wrap and secured with metallic tape. Connected black flexible insulated ductwork to distribution system. Installed condensate drain pan at base of unit. Verified all copper refrigerant lines properly connected and insulated. Ensured electrical connections secure at outdoor unit. System tested and operating within manufacturer specifications.

Completed annual cooling system tune-up and preventative maintenance on 15-year-old air conditioning unit. Inspected condensate drain pan and added algae prevention tablets to prevent biological growth and ensure proper drainage throughout the cooling season. Performed standard maintenance procedures including system performance evaluation and documentation with photographic records.

Completed sales estimate for aging residential HVAC system installed in basement utility room. Documented existing air handler unit with associated ductwork, including vertical metal supply ducts with foil-taped connections, flexible ductwork, and refrigerant lines. System shows significant age with visible wear on components and ductwork connections. Photographed current installation configuration including plenum assembly, copper refrigerant piping, and mechanical room layout to provide comprehensive assessment for equipment replacement recommendations.

Responded to main bathroom for leaking faucet repair. Upon inspection, identified leak at traditional two-handle chrome faucet with porcelain handle inserts on white oval sink. Disassembled faucet handles, replaced worn cartridges and seals, reassembled unit, and tested both hot and cold water lines to confirm leak was eliminated and proper operation restored.