Top-Rated HVAC & Plumbing Services in Spring Lake, MI

Completed rough-in plumbing cap and cover work in basement utility area. Successfully capped exposed plumbing lines and installed proper covers to protect rough-in connections, preventing potential water damage and ensuring code compliance. Work area left clean with all plumbing penetrations properly sealed.

Replaced four exterior soffit light fixtures showing significant rust corrosion and deterioration around the trim rings due to moisture exposure and age. All fixtures were successfully removed and replaced with new units, restoring proper illumination and eliminating safety concerns associated with corroded electrical components in the exterior soffit area.

Responded to master bathroom toilet with slow flushing issue. Performed diagnostic evaluation and applied blue dye test to identify flow restriction or potential blockage in the drainage system. Based on the testing procedure visible in the service photos, assessed toilet performance and water flow patterns to determine the cause of the sluggish flush operation.

Completed utility sink installation in basement area, including full rough-in and finish plumbing. Installed new water supply lines using copper piping with brass compression fittings and T-joints to create dedicated hot and cold water feeds. Mounted two PVC supply risers with blue-handled shutoff valves for independent water control. Set white utility sink with chrome two-handle faucet and connected to existing drainage system using white PVC waste lines with proper venting and trap configuration. All plumbing connections tested and verified leak-free upon completion.

Completed annual heating and cooling maintenance on 14-year-old Carrier system. Performed furnace tune-up including inspection of burners, heat exchanger, blower assembly, and safety controls. Conducted air conditioning tune-up with refrigerant charge verification, condenser coil cleaning, and electrical connection inspection. System operating within manufacturer specifications with no humidifier present on equipment. All components tested and found functioning properly for continued reliable operation.

Responded to no heat call where furnace failed to start. Upon inspection, found condensate drain pan full of water, indicating a blocked condensate drain line or failed condensate pump preventing furnace operation due to safety float switch activation. Cleared condensate drain system, verified proper drainage, and restored furnace to normal operation with heat confirmed at registers.

Conducted on-site assessment for secondary sump pump installation in basement utility area. Evaluated existing sump pit with corrugated metal walls and standing water, documented current PVC discharge piping configuration, and identified optimal placement for backup pump system to provide redundant water removal capability during primary pump failure or power outage scenarios.

Relocated plumbing pipe protruding through basement floor to accommodate upcoming carpet installation. Pipe was originally positioned in the center of the room, creating an obstruction for flooring work. Successfully repositioned the pipe and installed a drain pan with proper PVC fitting to ensure code compliance and protect the new flooring. Work area prepared and ready for carpet installation to proceed.

Completed annual heating maintenance on EnergiAir Elite Series high-efficiency furnace (97.0 AFUE rating). Performed comprehensive tune-up including filter inspection, burner assembly cleaning, heat exchanger examination, blower motor lubrication, and combustion analysis to ensure optimal performance for the heating season. Inspected humidifier system, verified proper PVC venting and condensate drainage, confirmed all safety controls operational, and documented equipment condition with photographs for service records.

Conducted comprehensive on-site evaluation of existing water heater and plumbing infrastructure to provide estimate for new water conditioning system and filtration equipment installation. Assessed basement utility area including current water heater configuration, copper supply line routing, venting system capacity, and available space for additional water treatment equipment. Documented existing plumbing connections, shut-off valve locations, and structural considerations for proposed system integration.

Completed tankless water heater tune-up on Rinnai unit. Serviced and cleaned intake air filter, removing accumulated dust, debris, and organic material buildup that was restricting airflow. Filter was thoroughly cleaned and reinstalled to ensure proper combustion air supply and optimal unit performance.

Completed annual cooling maintenance on 5-year-old Goodman AC system. Performed comprehensive tune-up including inspection of outdoor disconnect box, which revealed significant corrosion on copper connections and terminals, accumulated debris including leaves and dirt, and rust deterioration at base of enclosure. Documented equipment condition with photos for maintenance records.

Completed annual heating maintenance on 28-year-old Lennox furnace system without humidifier. Performed comprehensive tune-up including inspection of blower motor assembly, electrical connections, and internal components. Verified proper operation of FASCO blower motor, checked all wire connections and terminals for secure contact, and inspected burner assembly with focus on ignition components. Documented equipment condition with photos showing blower motor housing, electrical wiring, and internal mechanical components. All systems tested and confirmed operational for heating season.

Completed full furnace replacement in residential utility closet. Installed new dark gray furnace unit with proper vertical positioning and secured all manufacturer safety labels. Connected silver metal supply ductwork to unit discharge with appropriate angles and sealed all joints. Installed white PVC condensate drain and vent piping along right side of unit with secure mounting. Verified proper clearances from adjacent water heater and surrounding walls per code requirements. Tested all electrical connections, gas line integrity, and airflow distribution. System commissioned and operational, meeting manufacturer specifications.

Returned to property to complete re-installation of gas line on covered porch for outdoor grill connection. Gas line was properly routed along ceiling support beams and secured with appropriate mounting hardware. Installation completed as scheduled with all work performed in accordance with local gas fitting codes and safety standards.

Responded to service call for humidifier with continuous water flow that would not shut off. Upon inspection, found the solenoid valve failed in the open position, allowing water to run constantly through the unit and into the drain. Replaced the defective solenoid valve assembly and verified proper operation through multiple heating cycles. Confirmed water flow now activates only when humidity call is present and shuts off completely when demand is satisfied, with all drainage functioning properly and no leaks detected.

Provided estimate for air conditioning system replacement at residential property. Inspected existing outdoor condenser unit with white cabinet and black fan grille, noting unit positioned against house exterior on concrete pad within timber-framed recessed area. Customer expressed interest in current promotional offerings for new AC system installation.

Completed annual heating and cooling maintenance on 15-year-old Goodman furnace and 6-year-old Amana air conditioning system. Performed comprehensive tune-up including electrical diagnostics with digital multimeter, recorded operational measurements, inspected outdoor condenser unit, and verified system performance parameters meet manufacturer specifications.

Responded to no-heat call on 36-year-old original furnace with no maintenance history. Upon inspection, diagnosed failed inducer motor causing unit inoperability and strange noises. Furnace has exceeded expected lifespan with all original components intact and is installed in tight clearance configuration adjacent to water heater. Documented equipment condition with photos and advised customer that unit is past its service life expectancy. Recommended replacement over repair due to age and likelihood of additional component failures. Will follow up with repair cost estimate, though replacement is strongly recommended given the advanced age and lack of previous service history.

Responded to service call for dripping laundry room faucet and persistent odor from household drains. Inspected dual-handle chrome faucet at laundry sink and examined drain system beneath sink, including P-trap configuration and PVC plumbing connections. Addressed dripping faucet issue and assessed drain system for source of recurring foul odors affecting all sinks throughout the residence.