Top-Rated HVAC & Plumbing Services in Grand Haven, MI

Completed sewage pump replacement in a sump pit, addressing visible corrosion and standing water issues. Installed new pump with proper PVC pipe connections and verified system operation to ensure effective drainage functionality.

Inspected basement flooding in storage room area where water had been accumulating for four days. Identified water intrusion around pipe penetration through concrete block wall and moisture accumulation around water heater base. Determined that installation of a sump pump system would be the appropriate solution for ongoing water management in this 30+ year old home.

Completed annual maintenance on EnergiAir WT 04-2035 furnace (0 years old). Performed standard tune-up procedures and inspected humidifier system. Documented components with photos, including the flexible duct connection and condensate drain assembly. System is operating within normal parameters with no issues identified.

Diagnosed 15-year-old water heater repeatedly tripping GFCI outlet. Inspection revealed failing heating element causing electrical fault to ground. Recommended replacement of aging unit due to age and potential for further electrical issues.

Responded to no-heat call for 3-year-old EnergiAir furnace. Diagnosed water accumulation in condensate pan and red fault light on sensor. Inspected system components, cleared drain line, and reset system to restore proper operation. Unit is now functioning within normal parameters.

Completed estimate for a 150A to 200A electrical panel upgrade and backup generator installation. Inspected existing service panel mounted on exterior wall adjacent to HVAC equipment. Evaluated basement utility area for generator connection routing and assessed proper placement options for the new equipment.

Diagnosed restricted water flow in shower causing limited hot water duration. Removed and inspected shower head cartridge, revealing significant mineral buildup and corrosion. Cleaned mineral deposits from cartridge to restore proper water flow and pressure balance between hot and cold supplies.

Responded to service call for downspout to French drain system backup causing basement moisture issues. Inspected exterior drainage system and identified blockage in the connection between downspout and underground French drain. Cleared obstruction and verified proper water flow, resolving the backup problem that was causing water intrusion into basement.

Completed annual heating tune-up on 2014 EnergiAir WT 03-2034 furnace with humidifier. System was operational with no reported issues. Inspected electrical components including fuses and verified proper system function.

Performed annual heating maintenance on 8-year-old ENE furnace (warranty through 2027). Utilized borescope inspection to identify significant corrosion and buildup in heat exchanger. Cleaned flame sensor per service requirements. System operational but noted substantial internal deterioration requiring monitoring.

Performed diagnostic inspection on non-functioning HVAC system, accessing internal components including circuit board, motor, and wiring connections. Inspection of electrical panel revealed cluttered wiring with potential connection issues affecting furnace operation; restored proper electrical connections and verified system operation before closing access panels.

Diagnosed and replaced non-functioning garbage disposal unit that customer reported had been inoperative for approximately six months. Verified proper electrical connections and drainage configuration after installation. Tested new unit for proper operation and confirmed all connections were secure with no leaks.

Inspected plumbing shut-off valve and supply line assembly showing signs of water stains around fixture. Documented condition with photos for reference and scheduled return visit for replacement of defective part.

Performed inspection of 24-year-old water heater requiring replacement, located in confined utility space. Documented existing installation with photographs showing copper supply lines, ventilation, and current unit positioning. Provided customer with replacement options and information on Comfort Club membership, noting their plans for future HVAC system replacement.

Successfully installed a new Bradford White 40-gallon natural gas water heater in utility room. Properly connected copper water lines and PVC venting system, ensuring all connections were secure and leak-free. Unit was tested and confirmed to be functioning correctly with appropriate safety measures in place.

Inspected water heater system in response to customer report of inconsistent water temperatures across multiple fixtures. Examined shower valve and temperature controls which showed no visible damage or corrosion. Identified and adjusted mixing valve settings to ensure proper temperature regulation throughout the home's water distribution system.

Performed annual heating service on furnace and humidifier system. Inspected and replaced worn rubber drain hose that showed significant deterioration. System operational with proper functionality restored; next warranty tune-up due in 2025.

Installed new water shutoff valve for refrigerator water line. Connected valve to existing copper water line that previously had no shutoff capability, enabling proper installation of customer's new refrigerator. Verified proper operation with no leaks after installation.

Responded to water leak complaint at water heater base. Inspected cylindrical water heater installed in basement/utility room with copper plumbing connections and metal vent piping. Identified and resolved leak source, ensuring proper operation of the residential hot water system.

Investigated water leak concern around 12-year-old Tempstar furnace. Upon inspection, determined condensate drain line was properly functioning with dry drain pan. Examined HVAC ductwork and PVC drainage system to verify no active leaks or moisture issues.