Best AC, Heating, Plumbing & Generator Services Near You in Grandville, MI

Replaced kitchen receptacles and switches with new devices, and installed lighting and a control switch beneath the deck. Installed an outdoor weatherproof post-mounted receptacle near the waterfront to supply power for the pontoon boat charger, and verified proper operation of all circuits and fixtures.

Diagnosed a leak at the toilet floor seal and serviced the toilet's base connection, including inspection of the supply line and angle stop valve connections to rule out other moisture sources. Verified the bidet-style seat attachment and tank fittings were secure, and confirmed the unit was functioning properly with no active leaks at completion.

Installed a new Bradford White gas-fired water heater in the basement mechanical area, set within a drain pan with the gas control valve and thermostat. Connected the copper supply piping with shutoff valves, gas supply, and flue venting to the existing metal duct, and verified all connections were secure with no visible leaks, corrosion, or damage.

Responded to a malfunctioning ductless mini-split heat pump system serving the garage. Inspected the wall-mounted indoor air handler and outdoor condenser, including the refrigerant line set, electrical disconnect, and flexible conduit connections, and found no visible frost, ice, rust, or physical damage. Evaluated system operation and performance to diagnose the reported heating issue and verify proper function.

Responded to a leaking 12-year-old Lochinvar gas water heater and evaluated the unit, including the tank, gas control valve, flue connection, and supply piping. The unit showed no visible rust, frost, or damage, so the leak source was isolated and the installation was confirmed to be in order, with the flue properly routed to the ductwork and the gas line and pipe insulation intact. The customer was advised on the unit's age and service condition.

Removed the existing garbage disposal and installed a new unit, reconnecting the drain elbow to the PVC discharge piping and restoring the electrical power supply. Verified secure slip-joint connections and proper drainage operation with no leaks at the completed installation.

Inspected the kitchen sink drain assembly for a recurring intermittent leak on the left side and identified a loose, improperly seated slip-joint connection at the P-trap. Disassembled the affected joint, reseated the slip-joint washer and nut, and re-tightened all connections. Ran water through the sink and disposal to verify no leaks remained, and confirmed the cabinet interior was dry.

Replaced a portion of the drain stack, cleanout, and approximately 30 feet of underground piping serving the floor drain and washer discharge, including concrete demolition and finish restoration. The new piping eliminates standing water in the lines and removes scale and grease buildup from the underground drain system. Work is backed by a 1-year workmanship guarantee.

Performed annual heating tune-up on the furnace, including inspection and servicing of major components. Noted that the condensate drain line is disconnected, with a gap at the PVC coupling and rust-colored staining and residue at the open end of the pipe, indicating condensate discharge outside the intended drain path; recommend reconnecting and securing the drain line and inspecting the heat exchanger and secondary components for corrosion. No humidifier is installed on the system.

Returned to complete the follow-up portion of the previous shower repair by applying sealant around the shower valve trim escutcheon where it meets the tile wall. Inspected the surrounding tile, grout, and fixtures and found no visible cracks, leaks, or damage, with the valve trim and shower heads in good condition.

Performed annual maintenance tune-up on 13-year-old Lennox furnace (manufactured 2014), with no humidifier service required. Inspected the adjacent water heater and found heavy corrosion and mineral buildup at the top fitting and copper connection, with rust deposits on the tank top and a corroded blue washer, indicating a slow leak at the connection. Recommend evaluation and repair or replacement of the water heater fitting to prevent further deterioration.

Returned to address a plumbing line damaged during bathroom demolition and completed the shower update. Inspected the affected supply line, performed the necessary repair, and verified connections were secure and leak-free. Confirmed proper operation of the shower valve, tub spout, and hand shower hose, with the vanity faucet and drain also tested and functioning properly.

Inspected the under-sink garbage disposal reported to be leaking dark discolored water and found staining and moisture damage to the cabinet floor consistent with prolonged leakage. Disconnected and removed the failed disposal unit, including the drain fitting and electrical connection, and prepared the drain assembly for replacement. Provided a quote for a new garbage disposal.

Responded to a clogged kitchen sink drain with standing water and slow drainage in the basin. Inspected the under-sink P-trap and disposal drain assembly, then cleared the blockage from the drain line to restore proper flow. Verified normal drainage with the faucet running and confirmed no leaks at the slip-joint connections.

Installed a new upright gas furnace and AC system in the basement utility area, connecting it to the galvanized sheet metal supply plenum and existing ductwork. Routed and secured PVC condensate and combustion piping, tied in the whole-house humidifier with its drain line, and verified electrical and gas connections. Completed a final inspection of the installation, confirming secure connections and no visible damage or leaks.

Performed annual heating maintenance on 14-year-old furnace, including removal and inspection of the burner assembly. Found flame-spreader inserts on all three burners heavily corroded with rust and flaking, indicating advanced deterioration and potential for uneven combustion or flame rollout. Cleaned and inspected the assembly and combustion components, and recommended burner replacement to maintain safe, efficient operation.

Responded to a no-hot-water call on a 12-year-old Bradford White water heater whose pilot went out following a recent furnace maintenance visit. Inspected the Type B galvanized flue and vent connections, gas supply line, and surrounding venting for blockage, damage, or draft issues, and found the vent piping intact with no breaks or significant corrosion. Relit the pilot, verified proper ignition and flame, and confirmed the unit was heating and restored hot water.

Diagnosed a multi-zone hydronic boiler system in which one zone valve failed to close when its thermostat call for heat ended. Inspected the zone valve actuators and low-voltage wiring at the boiler, tested thermostat control signals, and verified proper valve operation and zone shutoff. The zone valve now cycles open and closed in response to the thermostat, and the system is operating normally.

Replaced the tub/shower faucet trim, shower head, and mixing valve with customer-supplied components, ensuring proper fit, secure connections, and leak-free operation. Also removed the existing bathroom sink hardware and installed a new brushed nickel widespread faucet with matching pop-up drain assembly, verifying smooth handle operation and watertight connections at all supply and drain points.

Performed annual heating tune-up on 9-year-old furnace, inspecting the unit's internal components and electrical connections. Verified the solenoid valve, supply tubing, and wire nut connections within the insulated cabinet were intact, with no signs of frost, rust, or visible damage. No humidifier is installed on the system.